Introduction To The Installation Of China 200w Led Flood Light Factory


China 200W Led Flood Light Factory takes out the sheathing wire for the matching battery board, and cuts the corresponding length (generally the length from the top of the light pole to the door plus 1.5 meters is appropriate

China 200W Led Flood Light Factory takes out the sheathing wire for the matching battery board, and cuts the corresponding length (generally the length from the top of the light pole to the door plus 1.5 meters is appropriate, there are parallel or series wiring and the battery board is installed on the side of the light pole The situation depends on the actual situation), peel off the end, and then wrap the two wires inside with adhesive tape (to avoid short circuit after connecting the front end to the battery board) and use the label paper as the battery board wire. Then use a screwdriver to open the cover of the terminal box of the battery board, peel off the front end of the wire, and connect it to the terminal of the terminal box through the head of the terminal box (note: it is generally stipulated that the red wire is connected to the positive electrode of the battery board, and the other is connected to the negative electrode), Make sure that the wiring is firmly behind the cover of the junction box (Note: This wiring method is the single-battery panel wiring method used in most cases, please refer to Appendix 1 for the wiring method of parallel or series connection of battery boards). And use nylon cable ties to fix the wires on the panel support. Then pass the end of the wire from the back of the sleeve through the threading hole, and then pass through the top of the lamp pole to the lamp pole door and lead it out of the door, so that the wiring below. Finally, install the entire part of the battery board on the top of the lamp post, adjust the angle of the battery board (make sure that it faces up to the south after being erected), and finally tighten the bolt with a wrench.
 
  Notes for China 400W Led Flood Light Factory:
 
   A. Before connecting the positive and negative poles of the output of the battery pack to the controller, measures must be taken to avoid short-circuiting.
 
  B. The output cable of the component should be kept from being exposed and tied with a cable tie.
 
  C. The orientation of the battery pack should be facing south, with the compass pointing.